📧 sales@skyutilityheating.com  |  ☎ +86 15343189075 Free Samples — Get a Quote

Farm Irrigation Piping 101: From Pump to Drip Tape

Home / Blog / Article
Buying Guide · 2026-10-24

A drip irrigation system is a chain of pipes in decreasing size: pump → mainline → manifold → laterals → emitters. Get each stage's sizing right and water reaches every plant evenly; get one wrong and you flood the first rows while the last rows stay dry. This guide walks through the piping, stage by stage.

Stage 1: PE mainline from pump or tank

The mainline carries the full system flow, so it is the largest pipe. Flexible LDPE/LLDPE coils (dn25–dn32) cover small and medium farms; larger schemes use HDPE supply pipe up to dn200+. Size it to keep water velocity below about 1.5 m/s — faster flow wastes pumping energy and amplifies pressure surges when valves close.

Stage 2: Manifold and zone valves

The manifold divides the field into zones. Each zone valve lets you run one block at a time, which means your pump only needs to supply one zone's flow, not the whole farm's. Quick coupling valves work well for portable setups; threaded or barbed valves for fixed layouts.

Stage 3: Laterals and drip tape

Laterals are the small dn16–dn20 lines running along each crop row, usually labyrinth drip tape per GB/T 19812.1 with emitter spacing of 200–400 mm and flow rates of 1–2.7 L/h. Two rules matter most:

The three most common mistakes

What to send us

Crop type, planted area, water source and daily irrigation window. We will propose mainline diameter, zone layout and a complete bill of materials — PE coils, drip tape, barbed fittings and valves — as one container-ready list.

Ask Our Engineer a Question

✉️ 💬